– 2 –
LINE MODE
2-1. Command Summary
The details of each command are shown in the following sections.
Commands to Select Characters
Control codes
Hexadecimal
Function Page
codes
<ESC> “R” n 1B 52 n Select international character set 6
<ESC> “/” “1” 1B 2F 31
Select slash zero
6
<ESC> “/” <1> 1B 2F 01
<ESC> “/” “0” 1B 2F 30
Select normal zero
6
<ESC> “/” <0> 1B 2F 00
<ESC> “b” n1 n2 n3 n4 1B 62 n1 n2 n3 n4 Select bar code printing 7
d1 ... <RS> d1 ... 1E
<ESC> “M” 1B 4D Select 12-dot pitch printing 11
<ESC> “p” 1B 70 Select 14-dot pitch printing 11
<ESC> “P” 1B 50 Select 15-dot pitch printing 11
<ESC> “:” 1B 3A Select 16-dot pitch printing 11
<ESC> <SP> n 1B 20 n Set character spacing 11
<SO> 0E Sets the printing magnified double in 12
character width.
<DC4> 14 Resets the printing magnified in 12
character width.
<ESC> “W” n 1B 57 n
Sets the magnification rate in character width.
12
<ESC> <SO> 1B 0E Sets the printing magnified double in 12
character height.
<ESC> <DC4> 1B 14 Resets the printing magnified in character 12
height.
<ESC> “h” n 1B 68 n
Sets the magnification rate in character height
.13
<ESC> “i” n1 n2 1B 69 n1 n2 Sets the magnification rates in character 13
width and height.
<ESC> “
–
” “1” 1B 2D 31
Select underlining
13
<ESC> “
–
” <1> 1B 2D 01
<ESC> “
–
” “0” 1B 2D 30
Cancel underlining
13
<ESC> “
–
” <0> 1B 2D 00
<ESC> “
_
” “1” 1B 5F 31
Select upperlining
14
<ESC> “
_
” <1> 1B 5F 01
<ESC> “
_
” “0” 1B 5F 30
Cancel upperlining
14
<ESC> “
_
” <0> 1B 5F 00
2. STAR LINE MODE
To Next Page
Loading...
