Star Micronics TSP700 Series - Vertical Tab; Set Line Spacing to 4 MM; Set Line Spacing to 3 MM; One Time N;4 MM Feed

– 19 –
LINE MODE
FUNCTION
Vertical tab
CODE
<VT>
HEX
0B
REMARKS
When start position detect is invalid, feeds the paper to the next
vertical tab stop and moves the print position to the left margin.
If no vertical tabs are set, this command is ignored.
Performs a line feed if the current line is at or below the last vertical
tab stop.
This command is ignored when start position detect is valid.
FUNCTION
Set line spacing to 4 mm
CODE
<ESC> “z”“1” or <ESC> “z” <1>
HEX
1B 7A 31 or 1B 7A 01
REMARKS
Sets the distance the paper advances in subsequent line feeds to
4 mm.
FUNCTION
Set line spacing to 3 mm
CODE
<ESC> “0”
HEX
1B 30
REMARKS
Sets the distance the paper advances in subsequent line feeds to
3 mm.
FUNCTION
One time n/4 mm feed
CODE
<ESC> “J” n
HEX
1B 4A n
REMARKS
Performs a line feed of n/4mm once only.
The value of n is 1 to 255.
Space setting for lines is not changed.