Star Micronics TSP700 Series - Page 51

– 48 –
PAGE MODE
FUNCTION
Define ruled line format
CODE
<ESC> “L n1n2 ; x1x2x3x4 , y1y2y3y4 , x5x6x7x8 ,
y5y6y7y8 , d , w” <LF> <NUL>
HEX
1B 4C n1n2 3B x1x2x3x4 2C y1y2y3y4 2C x5x6x7x8 2C
y5y6y7y82C d 2C w 0A 00
REMARKS
This command defines ruled line format.
n1n2 :Line number(00 to 63)
x1x2x3x4 :Position of the starting point in the X direction (0000
to 1040 × 0.1 mm)
y1y2y3y4 :Position of the starting point in the Y direction (0000
to 2000 × 0.1 mm)
x5x6x7x8 :Position of the ending point in the X direction (0000
to 1040 × 0.1 mm)
y5y6y7y8 :Position of the ending point in the Y direction (0000
to 2000 × 0.1 mm)
These four parameters work in 1/10 mm unit, and should be given
with four digit numbers.
d :Line direction d=0 : Horizontal line
d=1 : Vertical line
When d=0, then y1y2y3y4 = y5y6y7y8. When d=1,
then x1x2x3x4 = x5x6x7x8.
w :Line width 1 to 9 dots
Note: a) This command is used to define lines for label fram-
ing.
b) Up to 64 lines can be defined.
c) Lines must be vertical or horizontal (no diagonal
line).
d) The width of one dot is about 0.125 mm, and so four
dots make 0.5 mm width.
FUNCTION
Cancel ruled line format
CODE
<ESC> “E n1n2” <LF><NUL>
HEX
1B 45 n1n2 0A 00
REMARKS
This command cancels the line previously defined by<ESC> “L
n1n2”.
n1n2 :Line number (00 to 63)