12
Preheat time delay [T] press the key ，Modify the numerical change preheat time delay，Press enter to
confirm
3.2.2 Under the main interface press Enter the processing interface
【 F1】： BACKWARD ，Cutting nozzle along the trajectory of the original cut back（The I / O port is now closed）。
【 F2】： FORWARD，Cutting along the cutting path forward（The I / O port is now closed）;
【 F3】： RETURN，Cutting nozzle return to the starting point, namely the starting point of the workpiece。
【 F4】： N-PIERCE，Select any perforation point to cut
【 F5】： ZOOMIN，Graphic magnification
【 F6】： DELAY-，Reduce the preheating time and skip the remaining preheating time. Note: the system does not remember
the preheating time.
【 F7】： DELAY+，Increase the preheating time, increased to 15 seconds at a time。
3.2.3 Start processing
After selecting machining parts, and finish machining parameter is set, press the key ，System interface, the diagram
below：
To Next Page
Loading...
