18
4.6、 The edge of the thick plate perforation
1) In the automatic processing, need to use edge perforation method for thick plate processing。
2) edge of the perforation of the method is: will be in front of the punch cutting torch to move to the edge of the
plate recently.
3) Start preheating, when after the preheating, press【start】key，Cutting along a straight line and the selected cutting
speed cutting to punch, cutting processing again.
4) USES the edge notch, the first change parameter control menu of edge notch choice to 1 (said to choose
effective).So every hole, the first prompted the diagram below:
Location perforation
System position and perforation, for inner hole in common use
Select Edge of the hole
1） The operator can press【↑】【↓】【←】【→】，Adjust the position of the cutting torch to the outer limits of the
steel plate, start preheating;
2） When after the preheating, press【start】key，Cutting along a straight line distance and the selected
cutting speed to punch, cutting processing again.
Don't perforat
No perforation, system run directly from the current perforation position.Blank line to the next hole, a new perforation tip.
To Next Page
Loading...
Need help?
General
