11
【 F2】： Rotation correction, can use plate leveling function and manual rotation function
ROTATE：entering rotation correction interface, mobile cutting torch to plate production start position, press【 F1】Set
the starting point, the system coordinates automatically reset, and then move the cutting torch to the side to the other corner of
the plate on the same side board, press【 F2】SET The end, the system automatically rotating graphics.After the completion of
the correction, if prompted to return to the starting point, if the press【 ENTER】key，Then the system will return to the
correction of the starting position, if press【 ESC】 Then the system without any operation, returns to the graphical interface。
【 F3】： NEST， For simple discharge machining parts。
【 F4】： SCALE，Scaling set processing parts
【 F5】： SECTION，Choose from any perforation PM processing
【 F6】： EDIT，View and modify the current cut file
【 F7】： RESTORE，Cancel all operations, restore the graphics to the original state。
【 X】： Graphics to the X axis image
【 Y】： Graphics to the Y axis image
The second section setting processing parameters
3.2.1 Need to set the following parameters before processing：
Cutting pattern [G] Continuous press the key ，Patterns To switch between in the flame cutting, plasma and
presentation；
Cutting speed [F] press the key ，Modify the numerical change cutting speed， Press enter to
confirm
Manual speed [X] press the key ，Modify the numerical change cutting speed，Press enter to confirm
slot [N] press the key ，Modify the numerical change slot size，Press enter to confirm
To Next Page
Loading...
