14
The fourth chapter machining process
In the process of the content of this chapter is to introduce the processing needs of processing
4.1 Suspend operations
During processing, flame failure, interruption of arc voltage, or other need to suspend the case, press ，System to
stop working, and interface as follow：
【 F1】： BACKWARD ，Cutting nozzle along the trajectory of the original cut back。
【 F2】： FORWARD，Cutting along the cutting path forward;
【 F3】： RETURN，Cutting nozzle return to the starting point, namely the starting point of the workpiece。
【 F4】： N-PIERCE，Select any perforation point to cut
【 F5】： ZOOMIN，Graphic magnification
【 F6】： DELAY+，Increase the preheating time, increased to 10 seconds at a time。
【 F7】： DELAY END，End of preheating, skip the rest of the preheating time，
Note: press【 F7】 end the preheating time delay，The end of the current only delay, not log into the system, if you need
memory the preheating time delay time for system, press end time delay (memory)at the same time), start punch
processing
To Next Page
Loading...
