Static Power iSTS W - Maintenance Bypass; Fire Regulations; Standards Applied & Conformity; Warranty

1
.5 Fire Regulations
Should
a fire break out inside the system a fire extinguisher with CO
2
or similar non-conductive, non-
corrosive
and
inert gas must be used. Do not inhale vapours.
1
.6 Standards Applied & Conformity
The
iSTS B2 conforms to the following standards and European Council Directives:
Standards to which conformity declared:
▪ IEC 60950-1
Information
technology equipment Safety - General requirements
▪ IEC 62310-1
Static
transfer systems (STS) - General and safety requirements
▪ IEC 62310-2
Static
transfer systems (STS) - Electromagnetic compatibility (EMC) requirements
▪ IEC 62310-3
Static
transfer systems (STS) - Part 3: Method for specifying performance and
test
requirements
Application of Council Directives:
▪ 2006/95/EC
Low
Voltage Directive
▪ 1992/31/EEC
EMC
Directive
▪ 1993/68/EEC
EMC
Directive amendments
▪ 2011/65/EU
Hazardous
substances in electrical and electronic equipment - RoHS
iSTS W
– User Manual
Page 3
The Standards mentioned above fulfil
the requirements for CE marking
Year of CE marking: 2015-2016
1
.7 Warranty
Static
Power operating through its authorised agents warrants that the standard products will be free of
defects
in
materials and workmanship for a period of 24 months after the date of invoice, or such other period as may
be
specified
.
This
warranty does not cover failures of the product which result from incorrect installation, misuse,
alterations
by
persons other than authorized agents or abnormal operating conditions.
More
about warranty: staticpower.com.au/wp-content/uploads/2019/11/Warranty-Statement.pdf
1
.4 Maintenance Bypass
WARNING:
REFER TO THE MAINTENANCE BYPASS SECTION BEFORE ATTEMPTING TO PUT THE UNIT INTO MAINTENANCE
BYPASS MODE.
THE MAINTENANCE BYPASS SWITCH UTILISES MAKE
-BEFORE-
BREAK SWITCHING, INCORRECT OPERATION OF
THE MAINTENANCE BYPASS FEATURES COULD RESULT IN DANGEROUS VOLTAGES OCCURING AND SHORT
CIRCUITS.