16
Status Pro – T430 User Guide
Reset function
The reset function returns the RC310 to its factory settings. (Language: German;
Units: metric; Contrast: 40; Auto-off time: 10min).
To return the RC310 to its factory settings, press the ▲ buttons in the order shown
and keep pressed.
3.4 Communication between the RC310 and the
R310 Sensor
There are three kinds of signal that can be sent from the R310 to the RC310:
Laser position without controlling function
In this mode, the position value or measurement value on the R310 is transmitted to the
RC310 providing the R310 is set to RC310 in the menu and the IR button on the R310 has
been activated.
Laser position with remote controlling of the T430 Laser
When the remote controlling of a particular axis has been selected from the R310 menu,
the position of the laser beam will be moved accordingly. Additionally, the measurement
value will be transmitted to the RC310 along with the axis being presently controlled. The
values shown on the R310 can differ slightly from the value being displayed by the RC310
as the values for the laser positioning are evaluated slightly differently.
Again, to achieve laser positioning of the T430 Laser and obtain values on the RC310 the
infra-red on the R310 must be activated.
▲
▲
RC 310 REMOTE CONTROL
To Next Page
Loading...