Before using the CMC series
CMC Series Operation Manual 5
Installing TOOLS for CMC
NOTE
You are only permitted to use this software pursuant to
the terms and conditions of the “License Agreement”
shown during the installation.
Windows
Before installing
If the following warning messages appear during the
installation, click [Continue Anyway], [Yes], or [Install].
Example warning messages on Windows XP
E
xample warning messages on Windows Vista/Windows 7
Installation
1. Start the computer and log on to the
Administrator account.
2. Connect the device to the computer by using the
included USB cable.
The device’s built-in READY LED lights as soon as
the device is connected to the computer.
Windows XP:
If the “Found New Hardware Wizard” appears, click
[CANCEL].
Windows Vista/ Windows 7:
If a message such as “Device Driver Software was
not successfully installed” appears, click [Close].
3. Insert the TOOLS for CMC CD-ROM into the CD-
ROM driver.
4. Open the CD-ROM then double-click the file
“setup.exe.”
5. Follow the on-screen instructions to install the
software.
Install the following software in order.
• Yamaha USB-MIDI Driver
• Steinberg CMC Applications
6. When installation has been completed, click
[Finish].
If a window requiring you to restart your computer
appears, follow the on-screen instructions and
restart the computer.
Mac
Installation
1. Start the computer and log on to the
Administrator account.
2. Connect the device to the computer by using the
included USB cable.
The device’s built-in READY LED lights as soon as
the device is connected to the computer.
3. Insert the TOOLS for CMC CD-ROM into the CD-
ROM driver.
4. Open the CD-ROM then double-click the file
“TOOLS for CMC.mpkg.”
5. Follow the on-screen instructions to install the
software.
6. When installation has been completed, click
[Close].
To Next Page
Loading...
