Steinberg CMC Series User Manual

CMC-CH
CMC Series Operation Manual 7
CMC-CH
The CMC-CH allows you to intuitively control parameters
of the selected channel on Cubase.
Controls and Functions
NOTE
As soon as the device is connected to the computer, the
fader’s built-in LEDs light, and the lights move up and
down repeatedly a few times. The fader is then ready for
use.
If you touch the fader during this start-up, the fader may
not work properly. In this case, reconnect the device to
the computer.
Correspondence between the CMC-CH and Cubase
1 READY LED
Lights when connected to a computer.
2 Fader (Touch controller)
Adjusts the level (by slide operation). The fader value
lights.
Two fader operation modes are available: Catch and
Jump.
•Catch
This allows you to control the parameter value only
when your finger reaches the position of the fader
value.
•Jump
This changes the parameter value as soon as the fader
is operated, to the new value where your finger
touches.
This device is always started in the Catch mode. For
instructions on switching between the above operation
modes, see “SHIFT functions of each control” on page 8.
The fader resolution is 128 steps. (Audio channel: ∞ to
+6dB, MIDI channel: off to 127)
Holding down [SHIFT] while operating the fader
improves the resolution to 1024 steps, and lets you
adjust detailed parameters. At this time, the fader range
is 64 steps in normal editing.
3 [CH SELECT <] 4 [CH SELECT >]
(Channel Select button)
Shifts the selected channel forward/ back one level.
2
$
3
6
7
5
8
-1
9
)
@
8-2
!
#
8
-3
%
^
&
1
4
@
^
&
5
9
%
$
!
)
8
-1
8-2
8-3
2

Steinberg CMC Series Specifications

General

Brand	Steinberg
Model	CMC Series
Category	Controller
Language	English