22
EN
Signal Word Work Area Safety
The emergency switch has to be easily accessible at all times. Otherwise the machine can possibly not be
turned off in case of an emergency.
NOTICE
Keep children and bystanders at a distance while operating a power tool. Distractions can cause you to lose
control and can result in accidents.
NOTICE
Please imperatively make sure that the cable of the tool length sensor is long enough and will not be
clamped anywhere.
NOTICE Keep the work area clean and well lit. Cluttered or dark areas invite accidents.
Signal Word Personal Safety
Stay alert, watch what you are doing and use common sense when operating the power tool. Do not use the
power tool while you are tired and / or under the inuence of drugs, alcohol or medication. A moment of
inattention while operating the power tool may result in serious personal injury.
Depending on the application eld of the machine (private or commercial), observe the applicable occu-
pational safety and health, safety and accident prevention and environmental regulations as well. Ignoring
workplace safety can result in accidents.
NOTICE
Every person who operates the product must have read and fully understood all relevant safety and operating
instructions. Misunderstandings may result in personal injury.
1�2 General Safety Warnings
Signal Word Mechanical Safety
Never reach into the area between the tool and the sensor. Especially if a tool is being moved, there is a risk
of being injured by it.
Always make sure to have sufcient clearance to the mobile parts (guiding, milling cutters, shafts) and never
grasp into the machine with your hand. This may result in severe injuries!
Signal Word Electrical Safety
NOTICE
Never touch exposed components of the tool length sensor. There is a risk of damaging the product or re-
ceiving an slight electric shock.
Signal Word Use of the Power Tool
Disconnect the plug of the machine and the power tool from the power source before making any adjust-
ments, changing accessories, or storing power tools. Otherwise, there is a risk of electrocution and the
machine accidentally starting.
Do not alter or misuse the tool. Any alteration or modication is a misuse and may result in serious personal
injury.
Make sure that the tool holder, collet and clamping nut are securely clamped after changing an insertion
tool or making other changes. Loose elements can shift unexpectedly and cause a loss of control. Loose,
oscillating parts will be thrown around a lot. In addition, incorrect zero points can be determined.
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
To Next Page
Loading...