STEPCRAFT Touch Probe P100 - General Safety Measures; Required User Skills

24
EN
Unit Name Description
V Volt Voltage (potential)
A Ampere Current
Hz Hertz Frequency (cycles per second)
W Watt Power
kg Kilogram Weight
min Minute Time unit of 60 seconds
s Second Time unit
1
/
60
of a minute
mm Millimeter Metric size unit (
1
/
1000
of a meter - roughly 0,0394 inches) length, width, height
Inch Inch Imperial size unit (
1
/
12
of a foot - roughly 25,4 mm) like length, width, height
Ø Diameter Measurement through the center of a round form (like ‚thickness‘ of an end mill)
S Speed Revolutions per minute (also called RPM)
1
/
min
f Feed Feed in
mm
/
s
speed in which a machine moves in a direction
The following units can be relevant to your understanding of the tool:
1�4 Required User Skills
The product is only to be operated by technically skilled persons, 14 years or older, who are experienced in dealing with
drilling / milling machines, including CNC machines or 3D printing machines. The product has to be operated with cau-
tion – basic mechanical skills are required. The improper operation of the product can lead to damage to the product and
property and can cause serious injuries.
Read these operating instructions as well as all accompanying documents in their entirety (including all relevant
documents of your CNC machine, accessories, control software) before using this product in order to become familiar with
the characteristics and the operation of the product. The operator is solely responsible for understanding and reading the
machine user guide and all relevant operating instructions in their entirety as well as for the storage of these documents
in immediate vicinity of the machine. The manufacturers instructions concerning the CNC machine and the tools, such
as this product, are to be adhered to.
1�5 General Safety Measures
The CNC gantry milling system is only to be used in a technically perfect condition which is to be ensured prior to each
operation. The emergency stop switch as well as, if applicable, additional safety devices, always need to be easily acces-
sible and fully functional.