STEPCRAFT Touch Probe P100 - Relevant Safety Symbols and Units

23
EN
Signal Word Use of the Power Tool
NOTICE
Do not allow familiarity gained from frequent use of the product to become common-place. Always remem-
ber that a careless fraction of a second is sufcient to inict severe injury.
NOTICE Take care that the machine does not collide with the clamping xtures when using the touch probe.
NOTICE
Check if the individual components are perfectly connected with each other before the rst commissioning
and in regular intervals later on.
Signal Word Maintenance and Others
NOTICE
The CNC gantry milling system is only to be used in a technically perfect condition which is to be ensured
prior to each operation.
NOTICE
Please only use this machine according to its intended use. If the machine is not used as intended, there is
a risk for persons and of material damages!
NOTICE
The operator is solely responsible for understanding and reading the machine user guide and all relevant
operating instructions in their entirety, as well as for the storage of these documents in immediate vicinity
of the machine. The manufacturer`s instructions concerning the CNC machine and the tools, such as the
milling motor, are to be adhered to.
1�3 Relevant Safety Symbols and Units
The following symbols can be relevant to your understanding of the tool:
Symbol Name Description
General warning symbol Alerts the user to warning notices
Read user manual Alerts user to read the manual before rst use
Use hearing protection Alerts the user to wear hearing protection
Use protective gloves Alerts the user to wear protective gloves (but never during operation!)
Use safety goggles Alerts the user to wear safety goggles
Grounding Alerts the user to make sure the electrical system is properly grounded
Unplug
Alerts the user to unplug the device from the power supply before
servicing the device