stewmac.com
30
Install the strings
String up and you’re done! Your uke is ready to play.
Tune your uke
The four open strings are G C E A. Have fun with your new
custom-built uke!
Adjust the nut height
If the string heights are comfortable, you’re almost done. If
the nut is too high, you can lower it by sanding material o
the bottom. Tape sandpaper to your table and slide the nut
on it until you’ve removed enough material. Hold the nut
against a piece of wood to keep square. Also smooth and
round the ends of the nut on the sandpaper.
If the nut is too low (unlikely), place a thin shim cut from
wood or a business card under it to raise it.
Oil the ngerboard and bridge
Before stringing up, wipe the ngerboard with ngerboard
oil or lemon oil. Use a Q-tip to do the same for the bridge.
Install the nut
Put a small drop of glue under the nut, and place it in posi-
tion. The strings will hold it securely.
To Next Page
Loading...
