Stiga WBE Series - 7. TROUBLESHOOTING; a) Hard starting; b) Inconsistent working; c) Loss of power whilst operating

8
EN
a) Hard starting
b) Inconsistent
working
c) Loss of power
whilst operating
– No fuel
– Stale fuel or build-ups in tank
– Incorrect starting procedure
– Spark plug disconnected
– The spark plug is wet or the spark plug
electrodes are dirty or placed inadequately
– Air lter clogged
– Incorrect oil for the season
– Fuel evaporation in the carburetor
(vapor lock) due to high temperatures
– Fault in carburation
– Hard starting
– Dirty electrodes or incorrect gap
– The spark plug cap is inserted incorrectly
– Air lter clogged
– Throttle trigger in «CHOKE» position
– Fault in carburation
– Fault in ignition
– Air lter clogged
– Fault in carburation
– Governor out of phase with respect
to the accelerator
– Check and top up (see 5.1.3)
– Empty fuel tank and rell with fresh fuel
– Perform the starting procedure
correctly (see 5.2)
– Check that the spark plug cap ts well
over the plug terminals (see 5.1.4)
– Check (see 6.6)
– Check and clean (see 6.5)
– Replace with proper oil (see 6.3)
– Wait for a few minutes then start again
(see 5.3)
– Contact a Licensed Service Centre
– Contact a Licensed Service Centre
– Check (see 6.6)
– Check that the cap is tted correctly
(see 5.1.4)
– Check and clean (see 6.5)
– Move the lever to the «FAST» position
– Contact a Licensed Service Centre
– Contact a Licensed Service Centre
– Check and clean (see 6.5)
– Contact a Licensed Service Centre
– Adjust the cable (see 6.7)
PROBLEM LIKELY CAUSE SOLUTION
7. TROUBLESHOOTING