Stihl 034 Series User Manual

65034, 036, 036 QS
Removing the throttle shaft:
 Unscrew the throttle shutter
fastening screw and pull the
shutter out of the throttle shaft.
VA
138RA200
 Ease the E-clip off the throttle
shaft.
VA
138RA192
 Pull the throttle shaft out of the
carburetor.
– Remove the torsion spring.
 Take out the idle speed screw (1).
VA
138RA193
1
 Fit the throttle shaft with torsion
spring and secure with E-clip.
 Fit the idle speed screw and
check that torsion spring is
correctly positioned.
VA
138RA194
 Fit the throttle shutter, round
notch first, in the throttle shaft.
Note:
Whole circumference of throttle
shutter must locate against choke
tube wall.
VA
138RA195
– Coat the throttle shutter fastening
screw with LOCTITE 270, see
13.2, and tighten down firmly.
Removing the choke shaft:
 Unscrew the choke shutter
fastening screw.
VA
138RA196
 Ease the E-clip off the choke
shaft and pull the shaft out of the
carburetor.
– Remove the torsion spring.
VA
138RA197
 After fitting the choke shaft,
check that torsion spring is
correctly positioned.
– Fit the E-clip.
VA
138RA198

Stihl 034 Series Specifications

General

Brand	Stihl
Model	034 Series
Category	Chainsaw
Language	English