Stihl BT 45 - 5 Shroud;Housing Parts; Handle Housing

12 BT 45
– Remove the air filter - b 8.1
: Unscrew the nuts (1) and pull the
manifold with flange off the
carburetor.
– Remove the fan housing with
rewind starter - b 6.1
1
VA
932RA238
: Take out the screws (arrows).
VA
932RA240
: Take the handle hose (1) out of
the guides (arrows) and pull it off
the handle housing.
– Remove the right-hand handle
housing.
VA
932RA241
1
– Lift the left-hand handle housing
and swing it just a little to one
side.
: Pull the fuel fuel hoses (1) off the
carburetor connectors.
: Disconnect the throttle cable (2)
1 2
VA
932RA242
from the slotted pin on the throttle
lever and pull it out of the spacer
flange (arrow). Do not kink the
throttle cable during this
operation.
– Remove the left-hand handle
housing.
Install in the reverse sequence.
– When reinstalling, first remove
the rubber buffers (1) from the
engine and fit them in the left-
hand and right-hand handle
housings.
932RA243
VA
1 1
5. Shroud/Housing Parts
5.1 Handle Housing