23BT 45
Install in the reverse sequence.
: Mak sure the choke shutter 
locates properly in the guides 
(arrows) in the handle housing 
and the choke lever. Check that 
choke completely seals the 
manifold (arrow) in the start 
VA
932RA232
position.
If you suspect a fault in the fuel 
system, see b
 4.3. In the case of 
problems with the carburetor or fuel 
supply system, also check and 
clean or replace the tank vent -
b
 8.5.
The carburetor can be tested for 
leaks with the carburetor and 
crankcase tester 1106 850 2905.
– Remove the filter cover - b
 8.1.1
: Disconnect the fuel hose from the 
carburetor.
VA
932RA215
: Push the fuel line (1) 
1110 141 8600 onto the 
nipple (2) 0000 855 9200.
VA
143RA172
2 1
: Push the fuel line with nipple onto 
the carburetor’s elbow connector 
(arrow).
232RA082
VA
: Connect the tester's pressure 
hose to the nipple.
VA
232RA083
: Close the vent screw (1) on the 
rubber bulb (2) and pump air into 
the carburetor until the pressure 
gauge (3) shows a reading of 
approx. 0.8 bar.
VA
232RA084
3
2
1
8.2 Carburetor 
8.2.1 Leakage Test