15BT 45
Install in the reverse sequence.
– Fit a new exhaust gasket.
– Apply sealant to the underside of
the screw head - b 11.
– Tighten down the screws -
b 3.3
Spark arresting screen (stub)
: Use a 15 mm wrench to unscrew
the stub (1).
– Clean the spark arresting screen
or install a new stub if necessary.
1
VA
932RA204
– Clean the thread of the stub and
coat it with sealing compound -
b 11
Follow the manufacturer’s
instructions.
– Screw home the stub and tighten
it down firmly - b 3.3
Troubleshooting - b 4.2
If the action of the starter rope
becomes very stiff and the rope
rewinds very slowly or not
completely, it can be assumed that
the starter mechanism is in order
but plugged with dirt. At very low
outside temperatures the lubricating
oil on the rewind spring may thicken
and cause the spring windings to
stick together. This has a
detrimental effect on the function of
the starter mechanism. In such a
case it is sufficient to apply a few
drops of a standard solvent-based
degreasant (containing no
chlorinated or halogenated
hydrocarbons) to the rewind spring.
Carefully pull out the starter rope
several times and allow it to rewind
until its normal smooth action is
restored.
If clogged with dirt or pitch, the
entire starter mechanism, including
the rewind spring, must be removed
and disassembled. Take particular
care when removing the spring.
Clean all parts with a standard
commercial solvent-based
degreasant containing no
chlorinated or halogenated
hydrocarbons - b 11.
Lubricate the rewind spring and
starter post with STIHL special
lubricant, see b 11, before
installing.
: Take out the screws (1) and lift
away the fan housing with rewind
starter.
Install in the reverse sequence.
1
1
VA
932RA160
6. Rewind Starter
6.1 General
6.2 Removing and Installing
To Next Page
Loading...