Stihl BT 45 - Operating Instructions; During Operation

20 BT 45
: Thread the starter rope through
the guide bush from outside and
fit it on the rope rotor - b 6.5
– Install the rope rotor - b 6.3.1
VA
176RA190
: Carefully remove the spring
clip (1) from the starter post and
pull the pawl (2) out of the rope
rotor.
Do not pull the rope rotor off the
starter post.
VA
932RA183
1
2
– Coat the new pawl with special
lubricant, b 11, and fit it in
position.
: Push the spring clip (1) into the
groove in the starter post, making
sure it points clockwise.
: Make sure the spring clip (1)
engages the guide peg (arrow)
on the pawl (2).
Handle the spring clip with care.
The rewind starter may not function
properly if the spring clip is
deformed.
– Install the rewind starter -
b 6.1
– Remove the right-hand handle
housing - b 5.1
: Disconnect throttle cable nipple
(arrow) from the throttle
trigger (1).
: Remove throttle trigger from the
pivot pin on the handle housing.
Install in the reverse sequence.
VA
1
932RA264
6.7 Pawl 7. Throttle Control
7.1 Throttle Trigger