32 BT 45
– Remove the engine - b 5.2.1
Leave the gearbox on the engine.
– Remove the pickup body.
: Pull out the fuel hose (1) and vent
hose (2) with grommet.
Install in the reverse sequence.
VA
932RA292
2
1
: Installation of the vent hose is
easier if its end is cut to an angle
of about 60° as shown.
VA
362RA166
ca.60
– Remove the left and right-hand
handle housings - b 5.1
– If necessary, remove the
complete assist handle
(accessory for planting auger)
along with the adapter.
– If necessary, remove the assist
handle (accessory for wood
drills).
: On machines with planting auger,
unscrew the planting auger (1)
and the adapter (2).
932RA106
VA
21
: On machines with a chuck,
unscrew the lock screw (1) (l/h
thread) from the chuck while
holding the shaft steady with a
13 mm open-end wrench (2).
1
VA
932RA107
: On machines with a chuck,
unscrew the chuck (2) with a T45
socket (1) 5910 890 0105. Hold
the shaft steady with a 13 mm
open-end wrench (3).
21
VA
932RA108
: Take out the screws (1) at the
front and back.
: Loosen the screw (2) and pull off
the rotary knob (3).
3
2
1
VA
932RA109
8.6.2 Hoses 9. Gearbox
9.1 Removing and Installing
To Next Page
Loading...