FR 460 TC-M
English
14
Mounting the Support Frame
N Remove shipping lock (adhesive
tape).
N Take the M10x20 screw (1) with
washer (2) out of the support frame.
N Mount the support frame (3) to the
powerhead (4) with screw (1) and
washer (2) – tighten down hex.
head screw with 17 mm wrench to
torque of 20 Nm (177 lbf.in).
Mounting the Drive Tube
N Push the lug (1) on the drive tube
into the slot (2) in the coupling
sleeve as far as stop.
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
N Tighten down the star knob (4)
firmly.
Mounting Loop Handle with Barrier Bar
N Fit the square nuts (1), raised sides
facing up, in the barrier bar (2); line
up the holes.
N Place the clamp (3) in the loop
handle (4) and position them both
against the shaft (5).
N Position the clamp (6) against the
shaft.
N Place the barrier bar (2) in position
as shown.
N Line up the holes.
Assembling the Unit
To Next Page
Loading...
