FS 40, FS 40 C, FS 50, FS 50 C
English
30
Winding line onto spool
N Use green-coded nylon line with a
diameter of 2.0 mm (0.08 in).
N Cut two 2 m (6ft 6in) lengths of
nylon line from the reel (special
accessory).
N Rotate the spool (2)
counterclockwise until the two arrow
points are in alignment.
N Push the straight end of each line
through one sleeve (5) in the
mowing head (3) until you feel a
noticeable resistance – and then
continue pushing as far as stop.
N Hold the mowing head steady.
N Rotate the spool counterclockwise
until the shortest line is about 10 cm
(4 in).
N If necessary, cut the longer line to a
length of about 10 cm (4 in).
The mowing head is now full.
STIHL AutoCut 5-2
Removing remaining nylon line
N Open the mowing head – hold it
steady with one hand and turn the
cap (1) counterclockwise.
N Disengage the spool (2), take it out
of the mowing head and remove the
remaining line.
Winding line onto spool
A prewound spool (special accessory)
may be used as an alternative to the
following procedure.
Schnur/LINE 2
681BA023 KN
5
Schnur/LINE 1
3
3
2
681BA024 KN
Schnur/LINE 2
Schnur/LINE 1
To Next Page
Loading...
