ENFR
17
0478 404 8800 A - EN
● Insert folding retainer (R) through the
bore and close the securing clip.
7.3 Installing the left hoe
● Lift basic unit (A) with the help of a
second person.
● Position hoe (C) so that the bores in the
shaft mount and the drive shaft align.
● Push hoe (C) onto the drive shaft.
● Insert folding retainer (R) through the
bore and close the securing clip.
7.4 Installing the running wheels
The running wheels are installed in the
same way as the hoes.
7.5 Installing the brake spur
● Tilt the basic unit forwards as shown.
Risk of injury!
Hoes and running wheels must
always be installed in pairs. Never
install a hoe on one side and a
running wheel on the other side.
Strictly observe the installation
instructions. In particular, observe
the installation sequence and install
the hoe and folding retainer
completely as described. When
installing the folding retainer, strictly
observe the correct direction of
insertion and positioning of the
securing clip, as shown. In the case
of incorrect or rotated installation,
the folding retainer may come loose
and be lost.
For good working results, the
cutting edges of the hoes must
point forwards (not towards the
handlebar) – observe arrow
markings.
The hoe is marked with a sticker
(L - left).
To Next Page
Loading...
