0478 404 8800 A - EN
18
● 1 Insert brake spur (H) into adapter (1)
from below.
● 2 Fasten at lowest bore (2) with
pin (3).
● 3 Secure pin (3) with spring clip (4).
● Check that brake spur (H) is seated
securely.
● Fasten brake spur with bolt (Y).
7.6 Installing the transport wheel
● Tilt the basic unit backwards as shown
and support at the brake spur.
● Remove spring clip (1) and remove
pin (2) from the transport wheel.
● Pull out retaining pin (3), unscrew
castellated nut (4) and remove together
with washer (5).
● Remove bolt (6) from the transport
wheel.
● Fit transport wheel (1) onto frame (2).
● Fasten transport wheel (1) at the rear
bore with bolt (2), washer (3) and
castellated nut (4).
● Secure castellated nut (4) by bending
up pin (5).
To Next Page
Loading...
