ENFR
23
0478 404 8800 A - EN
Engine oil in oil bath air filter:
Please consult the engine
instruction manual for the type of
engine oil to be used and the oil capacity.
Check the oil filling level at regular
intervals (see engine instruction manual).
Avoid exceeding or falling below the
correct oil level.
Screw on the oil bath air filter cap properly
before operating the engine.
7.17 Installing the running wheels
● Open valve (1) on running wheel (K) to
allow air to escape.
● Unscrew bolts (1) together with
washers (2), spring washers (3) and
nuts (4).
● Remove rim halves (5) from rubber
tyre (6).
● Install axle mount (M) together with
bolts (1), washers (2), spring
washers (3), nuts (4) and rim
halves (5).
● Make sure that the valve at rubber
wheel (6) is positioned correctly in the
recess in rim half (5).
● Inflate the running wheel (2bar).
Risk of injury!
Deflate the running wheels before
carrying out any work on them (e.g.
dismantling the rim halves).
The running wheels are assembled
in the same way for both wheels.
To Next Page
Loading...
