0478 404 8800 A - EN
34
1. Wearing parts
Some parts of the STIHL machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
–V-belt
–Hoe
– Brake spur
2. Compliance with the information in
this instruction manual
The STIHL machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
– Use of fuel and lubricants not approved
by STIHL (lubricants, gearbox oil, petrol
and engine oil, see engine instruction
manual).
– Product modifications not approved by
STIHL.
– The use of attaching parts, attachments
or cutting tools not approved by STIHL.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
STIHL recommends that you have
maintenance operations and repairs
performed exclusively by a STIHL
specialist dealer.
STIHL specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage to the machine through the
use of inferior-quality spare parts.
– Damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
Folding retainer (hoes):
6250 716 4800
V-belt:
6250 711 5000
Right hoe assembly:
6250 710 0201
Left hoe assembly:
6250 710 0200
Repair kit (blade):
6250 007 1800
17.1 Petrol tiller (STIHL MH)
STIHL Tirol GmbH
Hans Peter Stihl-Strasse 5
6336 Langkampfen
Austria
declares under our sole responsibility that
complies with the relevant provisions of
Directives 2014/30/EU, 2006/42/EC,
2011/65/EU and has been developed and
manufactured in accordance with the
versions of the following standards valid
on the date of manufacture:
EN 709, EN ISO 14982, EN ISO 3744, ISO
11094
Storage of technical documentation:
STIHL Tirol GmbH
Product approval
The year of manufacture and machine
number (serial number) are indicated on
the machine.
Langkampfen, 02.01.2020
STIHL Tirol GmbH
16. Standard spare parts
17. EU - Declaration of
conformity
Design: Tiller, petrol
operated
Manufacturer’s
brand:
STIHL
Type: MH 610.0
Serial number: 6250
To Next Page
Loading...
