0458-004-0121-A
22
English
10 Operating the pressure washer
WARNING
When the lever of the spray gun is released, a recoil occurs
in the high-pressure hose. A recoil expands the high-
pressure hose. If the high-pressure hose is not completely
unwound from the hose reel, there is no room for the high-
pressure hose to expand and the high-pressure hose may
be damaged. Water can escape uncontrollably into the
environment at high pressure. This may result in serious
injury to people and damage to property.
► Completely unroll high-pressure hose.
► Completely unroll high-pressure hose (1).
10.3 Squeezing and locking the spray gun trigger
Pressing the spray gun trigger
► Move the retaining latch (1) to the position.
► Press and hold the trigger (2).
The high-pressure pump starts up automatically and water
flows out of the nozzle.
Locking the spray gun trigger
► Release the trigger (2).
The high-pressure pump switches off automatically and
water stops flowing out of the nozzle. The high-pressure
washer is still switched on.
► Move the retaining latch (1) to the position.
10.4 Settng the working pressure
Depending on the application, 3 power levels can be set.
The LEDs "POWER LEVEL" indicate the selected power
level. The higher the power level, the higher the working
pressure.
Work can be carried out with high working pressure if
stubborn dirt is to be removed.
Low working pressure can be used when removing soiling
from sensitive surfaces.
► Switch on high-pressure washer.
2
1
0000097568_002
2
1
0000097575_002
1
2
3
4
0000098505_001
To Next Page
Loading...
Need help?
General
