0458-004-0121-A
23
English
10 Operating the pressure washer
► Press activation key (1).
The activation key (1), the "BATTERY INDICATION" LED
(2) and the "POWER LEVEL" LED (3) light up green: The
working pressure can be set.
► Press the button (4).
This selects the next power level. After the third
performance level, it starts again with the first
performance level.
► Press pushbutton (4) repeatedly until the desired power
level is set
The control panel switches off automatically after 5 minutes
as soon as the pressure washer is switched off.
10.5 Cleaning
The 3-in 1 nozzle can be set according to the application:
– The fan-jet nozzle is suitable for cleaning light and
medium soiling.
– The rotary nozzle is suitable for cleaning stubborn dirt
on insensitive surfaces.
– The spray nozzle is suitable for cleaning with
detergent.
► Before cleaning, point the water jet at an inconspicuous
spot on the surface and check that the surface is not
damaged.
► Select the distance between the nozzle and the surface to
be cleaned so that the surface to be cleaned is not
damaged.
► Adjust the 3-in 1 nozzle so that the surface to be cleaned
is not damaged.
► Adjust the 3-in 1 nozzle only when the lever of the spray
gun is not pressed.
► Move the spraying equipment evenly along the surface to
be cleaned.
► Move forward slowly in a controlled manner.
10.6 Working with Detergent
Detergents can increase the cleaning effect of the water.
STIHL recommends the use of genuine STIHL detergents.
► Remove the detergent bottle (3).
► Unscrew cover (2).
0000098470_001
0000-GXX-5094-A0
To Next Page
Loading...
