0458-814-8221-A
27
English
12 After Finishing Work
► Rotate the fan-jet nozzle in the + direction to increase the
working pressure.
► Rotate the fan-jet nozzle in the – direction to reduce the
working pressure.
To clean:
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check that the
surface is not damaged.
► Work at a distance that allows you to effectively clean the
surface without damaging it.
► Adjust the fan-jet nozzle and distance from the surface to
be cleaned ensure the surface will not be damaged by the
spray.
► Move the spray attachment evenly along the surface to be
cleaned.
► Move forward slowly in a controlled manner.
12.1 Preparing for Transportation or Storage
To prepare the pressure washer for transportation or
storage:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Disconnect the pressure washer from the water supply.
► Press the spray gun trigger to relieve any remaining
pressure in the system.
► Lock the spray gun trigger.
► Disconnect the water hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► If the pressure washer will be exposed to freezing
temperatures, protect it with antifreeze or take other
measures outlined below, @ 12.2.
► Clean the pressure washer.
► Wind up the high-pressure hose (1) and stow it on the
bracket (2).
► Roll up the power supply cord (3) and hang it onto the
brackets (4).
► Secure the power supply cord with the clip (5).
► Insert the detergent spray set (6).
0000-GXX-4628-A0
12 After Finishing Work
1
2
4
3
5
7
0000-GXX-6405-A0
6
To Next Page
Loading...
