55
DEFRNLITESPTNOSVFIDAPLSLSKTR EN
0478 111 9953 B - EN
9.3 Adjusting the handlebar
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Detach the recoil starter rope from the
rope guide. ( 8.3)
● Hold the upper handlebar (2) with one
hand at its highest point and lift (relieve
load) slightly.
● Press the detent lever (1) downwards
and hold.
● Fold down handlebar (2) forwards.
Working position:
● Fold the handlebar (2) up rearwards
and ensure that the handlebar is fully
engaged.
● Attach the recoil starter rope at the rope
guide. ( 8.3)
Height adjustment:
The handlebar can be adjusted to 3
positions:
● Hold the upper handlebar (2) with one
hand at its highest point and lift (relieve
load) slightly.
● Press the detent lever (1) downwards
and hold.
● Move the handlebar (2) into the
required position.
● Release the detent lever (1) and ensure
that the handlebar is again fully
engaged.
9.4 Central cutting height
adjustment
RM 650 T, RM 650 V, RM 650 VE,
RM 650 VS, RM 655 V, RM 655 VS,
RM 655 YS:
Seven cutting heights can be set.
Level 1: 25 mm
Level 7: 85 mm
RM 655 RS:
Six cutting heights can be set.
Level 1: 20 mm
Level 6: 80 mm
● Pull detent lever (1) upwards and hold
in order to release the detent
mechanism. Set the required cutting
height by moving the machine upwards
or downwards.
● The cutting height can be read on the
cutting height indicator (2).
● Release detent lever (1) again and
allow the height adjustment to engage.
9.5 Battery and charger
(RM 650 VE)
The lawn mower RM 650 VE is
equipped with an electric starter. A lithium-
ion battery is used as the starter battery.
Instructions on how to use the battery and
charger can be found in the supplied
engine instruction manual.
Initial operation:
● Open protective cap (2) on the battery.
● Connect charger (K) to the mains
power supply and charge battery (J)
completely.
Removing and inserting the battery:
● Press release (3) and remove
battery (J) from the engine by pulling it
sideways and upwards and re-insert in
the opposite direction.
9.6 Level indicator
The flow of air generated by the
blade raises level indicator (1). The
flow of air stops when the grass catcher
box is full. If the flow of air is too low, level
indicator (1) returns to its resting state.
This is a prompt to empty the grass
catcher box.
The functionality of the level indicator is
restricted if the flow of air is impaired.
External influences such as wet, dense or
high grass, low cutting levels,
contamination or the like can impair the
flow of air and the functionality of the level
indicator.
A Grass catcher box is being filled
B Grass catcher box is filled
● Empty the filled grass catcher box
( 13.10).
Danger of pinching!
When actuating the detent lever,
always hold the upper handlebar
with one hand at its highest point.
Never place your fingers between
the handlebar and console (above
and below the detent lever).
The battery must only be charged
using the supplied charger; the
battery is not recharged during
operation of the lawn mower. Press
button (1) on the battery to check
the charge state.
To Next Page
Loading...
