EN
83
0478 131 8365 C - EN
– Close flap (Ö 15.2)
– Rectify displayed fault and confirm
message with OK (Ö 23.)
– End Homecall or repeat command
following docking
Fault:
The robotic mower is not working and
nothing is shown in the display
Possible cause:
– Machine is in standby
– Battery defective
Remedy:
– Press any button to wake up robotic
mower – status screen appears
(Ö 11.2)
– Replace battery (#)
Fault:
The robotic mower is noisy and vibrates
Possible cause:
– Mowing blade is damaged
– Mowing deck is very dirty
Remedy:
– Replace mowing blade – remove any
obstacles from lawn (Ö 16.4), (#)
– Clean mowing deck (Ö 16.2)
Fault:
Poor mulching or mowing result
Possible cause:
– Grass is too high in relation to cutting
height
– Lawn is extremely wet
– Mowing blade is blunt or worn
– Active times insufficient, mowing
duration too short
– Size of mowing area set incorrectly
– Mowing area with very high grass
– Long periods of rain
Remedy:
– Adjust cutting height (Ö 9.5)
– Adjust rain sensor (Ö 11.11)
Change active times (Ö 11.7)
– Replace mowing blade (Ö 16.4), (#)
– Extend or add active times (Ö 11.7)
Extend mowing duration (Ö 11.7)
– Create new mowing plan (Ö 11.7)
– For neat mowing results, the robotic
mower needs up to 2 weeks, depending
on the size of the mowing area
– Allow mowing in rain (Ö 11.11)
Extend active times (Ö 11.7)
Fault:
Display in a foreign language
Possible cause:
– Language setting has been changed
Remedy:
– Set the language (Ö 9.7)
Fault:
Brown (earthy) patches appear in the
mowing area
Possible cause:
– Mowing duration is too long in relation
to the mowing area
– Perimeter wire has been routed with
excessively tight radii
– Size of mowing area set incorrectly
Remedy:
– Reduce the mowing duration (Ö 11.7)
– Correct the routing of the perimeter wire
(Ö 12.)
– Create a new mowing plan (Ö 11.7)
Fault:
Mowing operations are significantly
shorter than usual
Possible cause:
– Grass is very high or too wet
– Machine (mowing deck, drive wheels) is
very dirty
– Battery has reached end of service life
Remedy:
– Adjust the cutting height (Ö 9.5)
Set the rain sensor (Ö 11.11)
Change the active times (Ö 11.7)
– Clean the machine (Ö 16.2)
– Replace the battery – observe
corresponding recommendation in the
display (#), (Ö 23.)
Fault:
The robotic mower is docked, the battery is
not charging
Possible cause:
– Battery does not need to be charged
– Docking station not connected to power
supply
– Incorrect docking
– Charging contacts corroded
– Power supply unit defective
– Machine is in standby
Remedy:
– No action necessary – battery charging
occurs automatically below a certain
voltage
– Check power supply to the docking
station (Ö 9.8)
– Place the robotic mower in the mowing
area and send it back to the docking
station (Ö 11.6), check for correct
docking – if necessary, correct the
position of the docking station (Ö 9.1)
– Replace charging contacts (#)
To Next Page
Loading...
Need help?
General
