STIHLER ELECTRONIC ASTOPAD DUO310 - 11 Information Messages and Troubleshooting; Battery Status (Only for Devices with a Battery); Applied Part Temperature too Low

ASTOPAD
®
Instructions for Use
11 Information messages and troubleshooting
50
11 Information messages and troubleshooting
11.1 Battery status (only for devices with a battery)
Control panel
Information
condition
The battery is defect or no original battery is inserted.
Device response
After the Start screen in mains operation and in Standby
mode, the display (11, 8) shows the crossed-out battery
symbol.
►Required
action(s)
►Insert new original battery.
The battery should be replaced every 3 years to ensure
adequate battery capacity.
11.2 Applied part temperature too low
Control panel
Information
condition
The actual temperature (1) is lower than 20°C.
Device response
Display (1) shows L.
Possible reasons
►Required
action(s)
The actual temperature is outside the display range
►Heat applied part.