Wallrack User Manual
Set Level
Press Down button once to go to Set Level menu. Press Right button to
enter.
Use Up/Down buttons to select all or channels (24 ways: 1- 30, 6 ways: 1-
12). Press the Right button to set the level.
Use Up/Down buttons to select Input or an output level of 0-100%. Use
the Right button to set the level. Repeat as necessary to set other
channels.
Press OK to confirm changes, press OK again to save or press Esc to exit
without saving any changes.
User Manual v1.2 March 2006
14
To Next Page
Loading...
