Stratus ftServer 4900 Series - Connecting a System Directly to a UPS; Power Cord Summary; Power Cords for Ftserver Systems and Peripheral Components; Table 2-9. Power Cords - Ftserver Systems and Peripheral Components to AC Power

Power Cord Summary
Electrical Power Planning 2-7
PCNS monitors the UPS for an imminent power loss, and initiates an orderly shutdown
of the system before power is lost.
Connecting a System Directly to a UPS
Figure 11-2 shows how to connect the A-side power connectors of your system directly
to a UPS.
Power Cord Summary
Stratus supplies tested and approved AC power cords for the following components:
 ftServer systems and peripheral components
 PDUs
CAUTION
!
Place all power cords out of the way of foot traffic.
MISE EN GARDE
!
Éloigner tous les cordons d’alimentation du passage.
Power cords described as Domestic are made with American Wire Gauge (AWG)
cordage and are intended for use in North America. Refer to UL 62 and CSA C22.2,
No. 49. All other power cords are made with International cordage and are intended for
use in the specified countries, and other countries that use that standard.
Power Cords for ftServer Systems and Peripheral Components
Tabl e 2- 9 lists the available power cords that connect ftServer systems and peripheral
components directly to an AC power source (not to a PDU or to a UPS).
Table 2-9. Power Cords - ftServer Systems and Peripheral Components to AC Power
Marketing ID/ Plug Type Rating Length Locale
B50101F NEMA 5-15, UL/CSA
approved, to IEC 60320 C13
15A/127V 7 ft (2.1m) North America
(Domestic)
B50104F NEMA 5-15, UL/CSA
approved, to IEC 60320 C13
15A/127V 14.8 ft
(4.5m)
North America
(Domestic)
B50112F CEE 7 VII to IEC 60320 C13 16A/250V 14.8 ft
(4.5m)
Europe (Continental)