Stratus ftServer 4900 Series - Chapter 9 Installing the System in a Cabinet

Installing the System in a Cabinet 9-1
Chapter 9
Installing the System in a Cabinet
9-
Before installing the system in a cabinet, make sure that:
 You read the entire chapter and understand the entire installation procedure.
 Your cabinet meets the system requirements.
 The site has been properly prepared.
The requirements for the cabinet and for site planning are described in “Cabinet
Requirements” on page 6-1.
To install the system components in a cabinet, see the following topics and refer to
Figure 9-1, which identifies the system components:
 “Required Tools” on page 9-3
 “Numbering the Vertical Rails” on page 9-3
 “Installing PDUs (Optional)” on page 9-6
 “Installing a System Chassis” on page 9-11
 “Installing the System Enclosures” on page 9-21
 “Next Steps” on page 9-24