Stratus ftServer 4900 Series - Site Planning for Peripheral Components; Ftscalable Storage System Requirements; Table 7-1. Site Planning for Ftscalable Storage G3 Systems

Site Planning for Peripheral Components 7-1
Chapter 7
Site Planning for Peripheral
Components
7-
When planning a site for your ftServer system, consider the electrical, cooling, power,
and space needs of your peripheral components. Also consider which PCI adapters are
being installed, and the lengths of cables for the PCI adapters and peripheral
components.
This chapter contains the following information:
 “ftScalable Storage System Requirements” on page 7-1
 “Keyboard Requirements” on page 7-2
 “Peripheral Components for Windows-based Systems” on page 7-3
 “Peripheral Components for Linux-based Systems” on page 7-4
 “Peripheral Components for VMware vSphere-based Systems” on page 7-5
NOTE
The system temperature and humidity requirements
defined in Table A-2 are the minimum requirements the
site must provide. This chapter specifies the temperature
and humidity requirements for other components.
ftScalable Storage System Requirements
Tabl e 7- 1 provides basic site-planning information for ftScalable Storage G3 systems.
You need some of this information to complete the worksheets in Chapter 2.
Table 7-1. Site Planning for ftScalable Storage G3 Systems
Specification Value
AC power (watts) 400
Nominal input voltage 100-240 VAC