Peripheral Components for Windows-based Systems
Site Planning for Peripheral Components 7-3
Peripheral Components for Windows-based Systems
Tabl e 7- 3 lists the PCI adapters required for each peripheral component on ftServer
systems running Automated Uptime Layer for Windows-based ftServer Systems.
To plan a site for a system on which Automated Uptime Layer and the Windows
operating system are installed, see the previous chapters in this manual. Also, see the
following manuals:
The ftScalable Storage G3: Getting Started Guide (R687) for information about
connecting ftScalable Storage G3 systems to ftServer systems
The Stratus ftServer Systems: PCI Adapter Guide (R461) for detailed information
about the PCI adapters
For additional information about third-party peripheral equipment that has been tested
with ftServer systems, see the following web site:
http://stratadoc.stratus.com/genref/refsell/qualified_equipment.html
Table 7-3. PCI Adapters and Peripheral Components: Windows-based Systems
Components PCI Adapters
External SAS tape drive (customer supplied) and ftServer 2900,
4900, or 6900 system
U114 Eight-Port SAS PCI-Express
Adapter
Fibre Channel ftScalable Storage G3 systems and ftServer
2900, 4900, or 6900 systems
U112A Single-Port 16-Gbps Fibre
Channel PCI-Express Adapters
iSCSI ftScalable Storage G3 systems and ftServer 2900, 4900,
or 6900 systems
Embedded Ethernet adapters
U113 Dual-Port 10/100/1000
Base-T Ethernet PCI-Express
Adapters
U117A Dual-Port Fiber
10-Gbps Ethernet PCI-Express
Adapter
†
U118 Dual-Port RJ-45 10-Gigabit
Ethernet PCI-Express Adapter
† Supported only in ftServer systems with the PCI-Express (PCIe) riser assembly, which is optional
in ftServer 4900 systems and standard in ftServer 6900 systems.
To Next Page
Loading...
