Safety
V 152 10 11 Rev.: END
2-5
2.6
Labels and signs on the gantry press
Sign Meaning Attachment location
+p
Text
sign
Warning of overpressure!
Caution!
Before starting servicing work, depressurise
the system.
Medium: Nitrogen
On the hydraulic
accumulators
Warning of hazardous voltage Signs on all junction
boxes, switch boxes
and control cabinets
for low voltage.
Protective conductor connection Next to the earthing
screws
2.7
Labels and signs to be attached by the plant operator
The plant operator is obliged to attach any other labels and signs to the gantry press
and in its immediate vicinity.
These labels and signs could refer, e.g. to the regulation for the wearing of personal
protective equipment.
2.8
Safety instructions for the operating personnel
The gantry press may be used only in a technically perfect condition as well as for the
intended purpose, in a safety-conscious manner and in consideration of these
operating instructions! All faults and in particular those which may impair safety must
be rectified immediately!
Every person who is authorised to start up, operate or service the machine, must
have read and understood these operating instructions before starting work, this
applies, in particular, to Chapter 2 Safety. Doing this once work has started is too late.
This applies in particular to personnel who work only occasionally on the gantry
press.
The operating instructions must always be ready to hand on the gantry press.
No liability shall be accepted for damage and accidents which occur due to non-
observance of the operating instructions.
Observe the relevant accident prevention regulations as well as the other generally
acknowledged safety and occupational health regulations.
To Next Page
Loading...
