Servicing
V 152 10 11 Rev.: END
6-1
6
Servicing
The chapter entitled Servicing is divided into the areas of care, maintenance and
repairs. This is intended to make it easier to schedule the required servicing work.
The instructions described in this chapter are to be regarded as minimum
requirements. Depending on the operating conditions, further instructions may be
required to keep the gantry press in an optimum state. The indicated intervals refer to
single-shift operation. Servicing instructions on specific assemblies can be found in
the corresponding documentation of the suppliers in Chapter 8.
The maintenance and repair work described in this chapter may only be performed by
specially trained repair personnel of the operating company.
Maintenance and repair work in specialist areas, e.g. hydraulic system, may be
performed by technicians trained in the particular specialist area only.
In the case of repairs and spare-part orders we refer to the drawings and parts lists,
which belong to the documentation, in Chapter 8 Appendices. This also applies to the
parts purchased by Strautmann Umwelttechnik GmbH.
Spare parts to be used must comply with the technical requirements specified by
Strautmann Umwelttechnik GmbH.
This is always guaranteed for original spare parts.
With reference to storage, handling, use and disposal of gases, greases, oils and
other chemical substances, the applicable regulations and safety data sheets of the
manufacturer as well as the instructions from the valid operating instructions of the
operating company must be read and observed!
Ensure safe and environmentally disposal of the operating materials and replacement
parts!
● Follow the safety instructions overleaf!
To Next Page
Loading...
