General information
V 152 10 11 Rev.: END
1-2
The plant operator must supplement the operating instructions with operating
procedures based on national regulations for accident prevention and for
environmental protection, including information on supervisory and reporting
obligations with regard to operational characteristics, e.g. with reference to work
organisation, work flows and utilised personnel.
Apart from the operating instructions and the obligatory regulations for the accident
prevention applicable in the country of use as well as in the location of use, the
acknowledged technical regulations for safe and correct operation must also be
observed.
The plant operator must not modify, extend or convert the gantry press without
authorisation from Strautmann Umwelttechnik GmbH! This applies in particular to the
installation and setting of safety equipment and safety valves as well as to welding
operations on load-bearing components.
Spare parts to be used must comply with the technical requirements specified by
Strautmann Umwelttechnik GmbH. This is always guaranteed when original spare
parts are used!
Use only trained or instructed personnel for the operation, maintenance, repair and
transportation of the gantry press. Clearly specify the responsibilities of the personnel
for operation, maintenance, repairs and transportation.
To Next Page
Loading...
