33
Issued: 24.02.2005
STRIDER MX
7.3 Overload protection - motor protection
The overload protection switches the drive off if the motor becomes
overloaded by trying to climb over too high an obstacle such as a
kerbstone, or if you try to climb too steep of an incline.
If the motor is overloaded, the following happens:
• the Strider becomes noticeably slower and then stops
• the control system switches the Strider off
Tipping hazard!
There is an increased tipping hazard if the incline is very steep.
• Try to get help from a second person when turning your
scooter around.
To rectify this:
Switch the scooter off and allow it to cool down for a few minutes.
Switch the scooter on again and ...
... reverse away from the obstacle (such as kerbstone) and then
try again at a lower point.
... be careful turning the scooter around on inclines, and always
reverse away very slowly.
➨
➨
Driving information
Accident hazard in push mode!
If the incline is too steep, there is a danger that you will not
be able to hold onto the scooter and that it will roll down the
incline uncontrolled.
• Try to get help from a second person when turning your
scooter round.
To Next Page
Loading...
