What to do if the Strong PrimaSat II remote control does not work?
If the remote control isn't working, check if the batteries are correctly inserted and not exhausted. Replace the batteries if needed.
What to do if my Strong Receiver switches off automatically?
The Auto Standby function may be enabled. Disable the Auto Standby feature. Please, refer to section 4.1.4 for details.
Why is my USB storage device not recognized by the Strong PrimaSat II?
If your USB storage device isn't being recognized, ensure that it's formatted with the FAT32 file system.
Demodulator| modulation | QPSK |
|---|---|
| input symbol rate | 2~45 Ms/s |
Video Decoder| profile level | MPEG-2 MP@ML |
|---|---|
| input rate | Max. 60 Mbits/s |
| video resolution | 720 x 576 pixels (PAL), 720 x 480 pixels (NTSC) |
Audio Decoder| sampling rate | 32, 44.1, 48 kHz |
|---|---|
| audio modes | Stereo, Dual mono, Mono |
Tuner| input frequency range | 950~2150 MHz |
|---|---|
| rf input level | -25 ~ -65 dBm |
| lnb power | 13/18 V DC (± 5%) max. 500 mA, Overload protected |
System and Memory| flash memory | 16 Mb |
|---|---|
| sdram | 64 Mb |
General Data| input voltage range | 100 - 240 V AC 50/60 Hz |
|---|---|
| power consumption | max 18 W, typ. 4.6 W |
| size | 179 x 130 x 44 mm |
General safety precautions for installation, usage, and cleaning of the receiver.
Details the components on the front panel: Indication LED, Remote Sensor, and USB Connection.
Identifies connections on the rear panel, including SAT IN for satellite signal.
Details the functions of each button on the remote control unit.
Guide to configuring OSD Language, Audio Language, and Subtitle Language settings.
Configuration settings for satellite dish type, including switch type and alignment.
Allows selection of the dish switch type: DiSEqC 1.0/1.1, DiSEqC 1.2/USALS, or NONE.
Configuration for DiSEqC 1.0/1.1, including satellite selection and signal strength check.
Setup for DiSEqC 1.2/USALS with motor-driven dishes, covering LNB type, location, and limits.
Settings for systems without DiSEqC, including Toneburst configuration for one or two dishes.
Accesses TV-related functions, including channel management and favorites.
Access to system configuration settings, including installation, TV setup, and PIN codes.
Contains submenus for OSD settings, My Dish, and TP Manager for system setup.
Settings for TV format, system (PAL/NTSC), OSD transparency, banner display, and video output.
Manages PIN code settings for various security features like menu and channel locks.
Resets the receiver to factory default settings, erasing all user data and preferences.
Procedures for updating the receiver's software via OTA or USB.
Instructions for updating software directly from the satellite (Over-The-Air).
Guide to updating software by downloading files to a USB device and connecting it.
To Next Page
