Factory Reset This function resets your DTV receiver settings back to the default factory settings. Press
OK and enter the PIN code to continue. Select OK to confirm executing the factory reset. This option
will delete all your channels, favourite lists and settings from the DTV. The receiver will reboot and
start with the First Installation menu of the DTV part.
WARNING: A factory reset will permanently delete all your personal settings, timers
and stored channels. The Android part is kept as it is. Please consider this
before you perform a factory reset.
7.4 Recording functions
The receiver supports instant recording, recording via timer and recordings booked via the Electronic
Programme Guide (EPG). First select the storage device on which you like to store the recordings
before you can use the recording functions. Connect the storage device and select DVR settings in the
DTV settings menu. After you have made recordings you can watch them by selecting the option DVR
from the DTV menu.
Press OK to open this menu. Select the recording you want to watch. At the right side of this menu
you can see the date and size of the recording. Press OK to start playback and use the multimedia
buttons for forwards, backwards, pause and stop. Press the RED Delete button to remove the selected
recording from the list.
7.5 Installation
In this menu you can select Satellite or DVB-T/Cable search and save the corresponding settings for
the channel search.
7.5.1 Satellite Installation
In this menu below you will find level and quality bars to optimize the signals for your dish.
Use p/q to select one or more satellites. Press OK to mark or unmark them. As soon as you have
made your selection, press u to jump to the right side of the screen where you can select a satellite
and add the corresponding settings as DiSEqC ports.
By the end of the setup you can start the scan process by pressing the BLUE and Scan button.
SAT Select a satellite with t u. If you only mark one satellite you cannot select another.
TP Select a transponder if you want to scan or adjust the dish on a selected frequency. Press OK to call
the overview list.
LNB type Default is set to 9750/10600 which is the most common setting for LNBs (Universal type).
Select another if you are using a different type LNB which needs other values.
LNB voltage Select On to increase the LNB voltage if you use a long coaxial cable to compensate for
decrease of the LNB supply voltage.
SatCR Select one of the frequencies if you are connected to a SatCR system. SatCR is a special system
which mainly is used in apartment buildings to provide one satellite dish system to many users
at once. To use this function, contact your property management or system installer. If SatCR is
activated, other settings below are not used. For normal use, default is set to Off.
LNB Power Default is set to 13/18V. The others functions are intended for specialized staff only.
22KHz Select Off or On if you use a special dish setup. For normal use this is default set to Auto.
20
To Next Page
Loading...
