To Next PageTo Next PageWhat causes a black-and-white screen or V-Hold on my Strong Receiver?
If you are experiencing a black-and-white screen or V-Hold issue with your Strong Receiver, it's likely that your TV mode (PAL/NTSC) is different from the satellite broadcasting mode. To resolve this, use a TV of the same mode or connect a NTSC/PAL converter between the receiver and the TV.
Why is there no picture or sound on my Strong Receiver?
If your Strong Receiver shows no picture or sound, there might be several reasons: * Check if the video/audio output is correctly connected to the TV input using RCA or HDMI cables. * Ensure the satellite antenna cable is properly connected. * Adjust the direction of the satellite antenna. * Verify cable connections, LNB, and other equipment between the LNB and the receiver, or adjust the antenna if the signal is weak or absent. * Make sure the channel information in the MENU screen is set correctly.
What to do if the Strong Receiver remote controller is not working?
If the remote controller for your Strong Receiver isn't working, try these steps: 1. Replace the batteries, as they may be exhausted. 2. Turn off any fluorescent lights that might be interfering with the remote. 3. Ensure you are aiming the remote control directly at the receiver.
General| Tuner Type | DVB-S2 |
|---|---|
| Resolution | Up to 1080p |
| Type | Satellite Receiver |
| Connectivity | Ethernet |
| Features | Multimedia playback via USB |
| Input Frequency Range | 950 MHz - 2150 MHz |
| DiSEqC | 1.0/1.1/1.2/USALS |
| Video Decoding | H.264 |
| Audio Decoding | MPEG-1 Layer I & II |
| Video Output | HDMI |
| Audio Output | HDMI |
| USB Port | 2.0 |
Lists the key technical specifications and capabilities of the receiver.
Provides essential safety guidelines for operating the unit.
Details important precautions for installation and usage.
Identifies and explains controls and indicators on the front of the receiver.
Details the various ports and connectors on the rear of the receiver.
Explains the functions of each button on the remote control unit.
Initial setup steps after powering on the receiver.
Instructions for setting up the satellite dish and LNB.
Process for scanning for available satellite channels.
Manage PIN codes, parental locks, and age limits for access control.
Initialize the smart card for accessing scrambled channels.
Lists common problems and their solutions for the unit.
