4) Security Settings
To prevent unauthorized access to classified programming, you can set a personal PIN
number for your receiver. (Note that the factory set default password is : 0000. PIN and
password are the same) <Figure 6.2.4>
By setting any of the following functions to in this menu, the PIN will be required to
access them;
- Receiver Lock, Install Lock, Channel Lock, Lock Channel Confirm
ᶀ
Age Limit (Parental Lock)
Under this menu you may select a Rating of programs you choose to block.
All available ratings are listed in the menu and when the program information regarding
the rating available from the broadcaster exceeds the selection, a PIN number is
required to access the program.
Use the scroll buttons to make your selection and press button to confirm.
This section also contains options to change and enter new passwords.
6.2 System Setting6.2 System Setting
<Figure 6.2.4>
2423
5) Database Reset
<Figure 6.2.5>
This section allows you to reset the receiver to the factory settings.
- Delete Radio Channels : Erase all radio channels in the database.
- Delete Scramble Channels : Erase all scramble channels in the database.
- Delete All Channels : Erase all channels.
- Factory Set : Erase all channels and restore the factory default settings.
<Figure 6.2.5>
6) IP Setting
If the Network supports DHCP , IP settings can be allocated automatically. If the Network
does not support DHCP, the Addresses must enter manually (Static IP).<Figure 6.2.6>
- Connection Type: Ethernet or WiFi. Select Ethernet if you are connecting the receiver
wireless network using the wireless USB dongle supplied with your receiver. (Please
note the wireless USB dongle is already inserted into the rear USB port or the receiver)
- DHCP Usage : On/Off to receive IP settings automatically
- IP Address : Enter the IP address
- Subnet Mask : Enter Subnet Mask Number from your Network
- Gateway : Enter IP address of Gateway (e.g. router)
- DNS : Enter IP address of main DNS Server
- Mac Address : Mac Address display
to the network via a LAN cable. Select WiFi if you wish to connect to your home
ҫ
Please note that a factory reset is required to be performed after a software upgrade.
Satellite TP data update from www.lyngsat.com.
To Next Page
Loading...
Need help?
General
