Strong SRT 497S - Installation Guide; Adding or Deleting Satellites; USALS Motorized System Setup

7
Installation guide
This receiver is preinstalled with Satellites. After turning on the receiver ， follow the first installation
guide to choose preferred menu language, HDMI output resolution, screen size and configure
internet connection through Ethernet or Wi-Fi.
Also, the first Installation guide helps you to search satellite TV / Radio channel manually, load
backup channel list from USB / SD card storage or load channel list from internet. We advise you to
download the TV / Radio channel list from internet automatically and you could watch TV
immediately.
Please contact our appointed customer service center for assistance if you have any question about
searching the TV / Radio channel list manually.
How to add or delete satellite?
1. Press MENU button on the remote to display the main menu.
2. Go to the first line (DVB-S2X Installation) and move to right, choose ‘’Dish Setting‘’, press OK
button, to display the “Dish setting” menu.
3. Press RED button to delete satellite, Press BLUE button to add satellite.
How to setup a USALS Motorized System
1. Press MENU button on the remote to display the main menu.
2. Go to the first line (DVB-S2X Installation) and move to right, choose ‘’Motorized Setting‘’, press
OK button, to display the “Motorized setting” menu.
3. Go to the third line(DiSEqC Motor) and use the
◀/▶ buttons on the remote to select USALS.
4. Go to “Local Longitude” and “Local Latitude” and enter the coordinates of where you live
(London’s Longitude is 00.1 West and South of UK’s Latitude is51.5 North).
5. Go to “Motor Setup” and press OK button. Wait until the Signal Quality is more than 40% in
the progress bar.
When a satellite is found, then all the selected satellites are fully configured for a Motorized
system.
If the Signal Quality is below 40%, then the settings are incorrect and the Longitude needs to
be adjusted.
For example: 00.2, 00.3, 00.4, 5/6/7/8/9 West or East. The Latitude may also need to be
adjusted.
If you still have not got a signal, then the external installation (dish, etc) needs to be adjusted.