PART 1 • English
9
English
5.1.4 Delete all
Use this menu to delete all channels. Select Delete All with the pq and press OK, then
enter the Password (default: 0000). In the confirmation window select Yes with tu and
press OK to delete or select No to cancel.
5.1.5 Group Rename
In this menu you can change favourite group name. Use the pq buttons to select
Group Rename and press OK to enter.
1. With the pq buttons select a group and press OK.
2. At the appearing Keyboard use the pqtu buttons to highlight desired
letters or numbers and press OK to insert. After you entered desired
group name, highlight OK at the keyboard to confirm.
3. Press EXIT button to cancel the group rename.
5.2 Installation
5.2.1 Auto Scan
1. Use the pq buttons to select Installation, press OK button to enter menu.
2. With the pq buttons select Auto Scan, press OK to enter the menu.
3. Press the tu buttons to change Scan mode, and use the pq to
highlight Search, press OK to start auto scan.
5.2.2 Channel Scan
1. Use the pq buttons to select Installation, press OK to enter the menu.
2. With the pq buttons to select Channel Scan and press OK to enter
the menu.
3. Use the tu buttons to select one of two Scan Modes – By Channel
and By Frequency.
4. When By Channel is selected use the cursor buttons to select Scan Band
and Channel No. When By Frequency is selected use the cursor buttons
to select Frequency and Bandwidth. Select Network Search to ON or OFF,
highlight Search and press OK to start scan. After Channels are found,
they will be stored and receiver switches to the first one saved in the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use the pq buttons to select Installation, press OK to enter the menu.
3. With the pq buttons select Antenna setting and press OK to enter.
4. Press the tu buttons to change setting. If On is selected, the receiver
will provide 5 V antenna power (for active antennas).
5. Press EXIT button to exit.
To Next Page
Loading...
Need help?
General
