PART 1 • English
13
English
press OK to start. Message will be displayed to confirm update process,
select “Yes” to confirm or “No” to cancel.
4. Press EXIT button to exit.
WARNING: After an update the receiver restarts automatically! During this
process NEVER disconnect the receiver from the main or switch
power OFF! This can damage your receiver and warranty will void!
Note: This receiver has foreseen an over the air update function, which might not
be available at your local broadcast conditions. For further details visit our
website www.strong.tv or contact your local Serviceline.
5.5 Media+
Select “Media+” and press OK button to enter Media+ menu.
1. Press MENU button to enter main menu. Select “Media+” and press OK
button to enter Media+ menu.
2. Press pq buttons to highlight desired menu and press OK button to enter.
3. Press EXIT button to exit.
Use the two button rows in bottom of RCU for Player operation. Description for usage
of buttons will be displayed on screen.
5.5.1 Media Player
This function allows you to play MPEG-2, Audio and Photo files from connected USB device
1. In “Media+” menu, select “Media Player” and press OK button to enter
Media Player menu.
2. Press pq buttons to select a desired item, and press OK or PLAY button
to play the desired files.
3. Press EXIT button to exit.
5.5.2 Safely Remove Storage Device
In “Media+” menu, select “Safely Remove Storage Device” and press OK button to safely
remove the USB device. Then a message is displayed.
6.0 OPERATION
6.1 Changing Channels
There are 4 ways of channel selection - stepping through the channel list, selection by
number, from the on-screen channel list, and using the electronic programme guide (EPG).
1. Stepping through the channel list
To move through the channel list, press the pq buttons on the
remote control.
2. Selected by number
Enter the channel number directly by pressing numeric buttons, and press
the OK button to select desired channel.